Changshu smoothly da plastic products factory interface process on the PP plastic tubing

PP can be used to make a variety of products, including plastic tubing. Many people are interested in PP plastic tubing interface process especially, smooth da plastic products factory in changshu then PP plastic tubing interface process to explain.



PP plastic tubing interface operation is PP plastic tubing is relatively common in the construction process of a way of operation, through the interface operation, two different PP plastic tubing can be connected together. Usually interface work installation location should be in port between the second and third corrugated groove, installation of seal number depending on the design requirements, when the two sealing ring is used suggested between the sealing ring to be a ripple.



PP plastic tubing will socket outlets should be taken before the interface inside and outside surface is clean, the socket set into the ring, and working around a socket and rubber ring surface coated with a layer of lubricant ( General with soap and water) And insert it into the direction is in the direction of flow. Aim at the center line of the socket or forcibly set wood dampers with jemmy will be installed within the PP plastic tubing slowly inserted into the socket until the bottom. After the completion of the interface, then use the same soil embankment of the reserved grooves into the dense. Socket pipe installation pin should be well flow direction, continues the mouth should be kept under flow direction, from the bottom up, in turn, installation.



it is important to note that after the PP plastic tubing interface, should check the bottom depth of the PP plastic tubing and axis, make plastic pipe meets the requirements, if the PP plastic tubing appear displacement, suspension, mouth pull phenomenon, should be rework process.