Better Touch Better Business
Contact Sales at CSSSLD.
Suspension assembly floor, ok?
by：CSSSLD
2021-01-23
Suspended splicing floor materials of environmental protection, and can effectively solve the problem of heat bilges cold shrink;
Anti-slip friction resistance, tear open outfit is convenient to use, are widely used in the basketball court, badminton courts and other sports venues, and kindergarten outdoor playground.
Due to the suspension assembled on the market floor quality good and bad are intermingled, so at the time of purchase suspension assembly floor must pay attention to the following three aspects: a, injection port
low-end: most of the low end of the suspension assembly injection mouth the center of the back on the floor, the floor and only one injection. Such injection: first of all need to manually cut, do manual work is coarser, injection mouth shape is very ugly appearance. Injection port is the only one, the central pressure, pressure is small, around will appear, the central module, playing around is not full, free bubble. More importantly, the central pressure, injection of the floor, the middle is up.
。 : most high-end suspension assembly floor injection port is on the floor board, and the injection port is off automatically, injection port more beautiful. Injection port usually has two or four or even six, uniform pressure distribution, full all round, no bubble, floor plain massiness.
2, surface treatment and fine degree
low: low end of the suspension assembly floor surface coarsely. Frosted surface treatment not beautiful, even some low-end products, did not do on the surface of the grinding processing.
。 : high-end suspended assembly floor surface fine workmanship and frosted surface treatment, forever in the industry before the grind arenaceous processing method, beautiful appearance, no extra edge material or broken Angle.
3, smell the low-end: low-end products, have peculiar smell, the summer breath is heavier, toxic, not environmental protection.
。 : high-end suspension assembly, the floor. And environmental protection.
knowledge of the above three purchase suspension assembly floor, can buy good products.
low-end: most of the low end of the suspension assembly injection mouth the center of the back on the floor, the floor and only one injection. Such injection: first of all need to manually cut, do manual work is coarser, injection mouth shape is very ugly appearance. Injection port is the only one, the central pressure, pressure is small, around will appear, the central module, playing around is not full, free bubble. More importantly, the central pressure, injection of the floor, the middle is up.
。 : most high-end suspension assembly floor injection port is on the floor board, and the injection port is off automatically, injection port more beautiful. Injection port usually has two or four or even six, uniform pressure distribution, full all round, no bubble, floor plain massiness.
2, surface treatment and fine degree
low: low end of the suspension assembly floor surface coarsely. Frosted surface treatment not beautiful, even some low-end products, did not do on the surface of the grinding processing.
。 : high-end suspended assembly floor surface fine workmanship and frosted surface treatment, forever in the industry before the grind arenaceous processing method, beautiful appearance, no extra edge material or broken Angle.
3, smell the low-end: low-end products, have peculiar smell, the summer breath is heavier, toxic, not environmental protection.
。 : high-end suspension assembly, the floor. And environmental protection.
knowledge of the above three purchase suspension assembly floor, can buy good products.
Custom message
